Product · panel + profiled · drift loss control
Drift eliminators
Panel-type and profiled drift eliminators for cooling towers and air-handling equipment — to cut drift water loss and aerosol emission.
Why it is not an optional part
A running cooling tower carries fine water droplets into the leaving air. The drift eliminator catches them: air can navigate the labyrinth of passages, the heavier droplets cannot — they hit the wall and drain back into the system.
That brings two separate benefits. One is economic: drift water shows up in the accounts as make-up water, chemically treated and pumped. The other is public health: drifting aerosol is the medium in which Legionella spreads. A broken, missing or displaced drift eliminator is therefore not a cosmetic fault — it degrades what the tower emits.
Panel and profiled versions
Panel-type drift eliminator: corrugated profile welded into rigid, finished panels. The most widespread cooling-tower solution — quick to replace, easy to keep clean, cut to the tower’s internal dimensions.
Profiled drift eliminator: assembled from individually fitted extruded profiles. Advantageous where a bespoke geometry must be filled, and in air-handling units, scrubbers and paint booths.
The main selection criteria are permissible air velocity and available installation depth: a deeper profile with more direction changes catches more effectively, at the cost of higher pressure drop.
Where else they are used
Drift eliminators are not only a cooling-tower part. The same principle works in gas scrubbers, the wet sections of air handling units, paint booth extraction and adiabatic systems — wherever droplets must be taken out of moist air before it travels on.
Versions
- Panel-type — Rigid welded panel — the typical cooling tower solution, quick to replace.
- Profiled — Individually fitted profiles — for bespoke geometry and air-handling equipment.
Technical data
| Material | PVC or PP versions |
|---|---|
| Version | panel-type and profiled |
| Installation depth | depending on profile, typically in the 10–20 cm range |
| Applications | cooling tower, gas scrubber, AHU, paint booth |
| Size | cut per panel, matched to the tower’s internal dimensions |
Indicative figures. Permissible air velocity, pressure drop and exact panel dimensions follow the datasheet of the selected type and appear in the quotation.
Frequently asked questions
How do I know replacement is due?
Typical signs: visible mist or dripping on the tower’s discharge side, wet patches around the tower, and broken, missing or displaced panels found on inspection. Aged PVC turns brittle here too.
How much water can it save?
Savings depend on tower size, air velocity and the condition of the old eliminator, so a responsible figure needs a survey. In principle: an intact eliminator reduces drift loss by orders of magnitude compared with a broken or incomplete one.
Can drift eliminators be cleaned?
The panel surface is more open than a fill pack, so deposits on it can be removed to a degree. For broken, deformed or embrittled panels, replacement is the right answer.
Request a quote
Describe the job — we assess it.
Site, equipment, deadline — that is enough to start. We respond on short notice.